New build, jammed round in chamber

Linear Mode

New build, jammed round in chamber - need help

bj139

Posting Freak

Posts: 1,973
Threads: 28
Joined: Mar 2017

#23

02-17-2018, 12:37 AM (This post was last modified: 02-17-2018, 12:41 AM by bj139.)

New parts need more lube until they break in. It is the same with any machine parts.

I have been forming wildcat cases using a light film of resizing lube and assembling a new receiver and BCG.

I found resizing lube, rubbed on the bolt and inside the receiver makes it run slick.

Find

« Next Oldest | Next Newest »

Messages In This Thread

New build, jammed round in chamber - need help - by warp9764 - 02-13-2018, 10:13 PM

New build, jammed round in chamber - need help - by Bigs28 - 02-13-2018, 10:22 PM

New build, jammed round in chamber - need help - by VASCAR2 - 02-13-2018, 10:29 PM

New build, jammed round in chamber - need help - by warp9764 - 02-13-2018, 10:39 PM

New build, jammed round in chamber - need help - by warp9764 - 02-13-2018, 10:40 PM

New build, jammed round in chamber - need help - by warp9764 - 02-13-2018, 10:45 PM

New build, jammed round in chamber - need help - by VASCAR2 - 02-13-2018, 10:49 PM

New build, jammed round in chamber - need help - by VASCAR2 - 02-13-2018, 10:57 PM

New build, jammed round in chamber - need help - by rwh - 02-13-2018, 11:15 PM