01-21-2018, 04:08 PM
Thanks for starting this, KSwt.
Wish now that I'd documented the last few assemblies.
BCA Side Charger:
Can confirm un-smooth mating surface. Looked almost like flashing on one side. Could have been coating drip.
Some coating buildup at base of pin slot. Tight pin fit after cleaning the slot.
Bedded with Permatex Green. 2 taps with dead blow hammer to seat.
~1.7mm total play around BCG.
Tight groups with 62gr reman .223 ammo thru inexpensive 16" .223 Wylde pencil barrel out to 100yds.
Wish now that I'd documented the last few assemblies.
BCA Side Charger:
Can confirm un-smooth mating surface. Looked almost like flashing on one side. Could have been coating drip.
Some coating buildup at base of pin slot. Tight pin fit after cleaning the slot.
Bedded with Permatex Green. 2 taps with dead blow hammer to seat.
~1.7mm total play around BCG.
Tight groups with 62gr reman .223 ammo thru inexpensive 16" .223 Wylde pencil barrel out to 100yds.