01-15-2018, 03:11 PM
LR:
Thanks for the information.
I will probably put this on the back burner for now and just buy the NiB bolt carrier group I posted about. I could use it on a 224 Valkyrie if barrels become available.
I had intended to try one bolt and mount a dremel with grinding wheel on my 6" lathe toolpost and grind while turning the bolt then clean it up with a carbide bit.
It might work. I will post if I try it.
Thanks for the information.
I will probably put this on the back burner for now and just buy the NiB bolt carrier group I posted about. I could use it on a 224 Valkyrie if barrels become available.
I had intended to try one bolt and mount a dremel with grinding wheel on my 6" lathe toolpost and grind while turning the bolt then clean it up with a carbide bit.
It might work. I will post if I try it.