12-06-2017, 04:06 PM
A question for VASCAR and others: If the chamber was reamed for a 0.136" bolt and the OP is using a 0.125" bolt, it would take factory ammo at least 0.011" short on headspace for the rifle to function. Is the factory ammo that short?
If that is the case, the FL sizing die would likely not set back the shoulder. THE OP didn't elaborate on his reloading problems. If this is it, he could find it quickly by measuring the shoulder location with a Hornady (or other) tool.
Clarence
Clarence
If that is the case, the FL sizing die would likely not set back the shoulder. THE OP didn't elaborate on his reloading problems. If this is it, he could find it quickly by measuring the shoulder location with a Hornady (or other) tool.
Clarence
Clarence