07-20-2017, 02:27 PM
(This post was last modified: 07-20-2017, 02:39 PM by funnelcake.)
JC - Can you tell if the barrel extensions are nitrided also? If so, I'd be curious if the proper order of assembly followed. My brother ordered a bunch of their stuff to try out: few stainless barrels, one plain 4150, three side charging complete uppers (one a lefty) and 5 complete BCG's.
If I get a chance I'll take one or two and shoot @ 100-yards. Alas though, they're all 5.56 or .223 Wylde. TBH the finish work on the carriers and bolt is just OK to my eye. Proof is in the shooting. I haven't seen or heard about any BCA stuff shooting under 1-MOA. Most seem to be 1-1.5 but still a low enough sample pool to be anecdotal. The one 6.5 barrel I ordered had a flat-out awful crown job and went back.
Those guys have a bunch of new equipment, etc. so the potential is probably there...a lot of the rest will be attention to detail IMO.
We're also going to run one of the BCG's in a 7.5" FA 5.56 and largely dump ~1000 rounds through it in short order; half with a can attached. I wish we could do more but that's a lot of ammo cost testing a $49 buck BCG!
If I get a chance I'll take one or two and shoot @ 100-yards. Alas though, they're all 5.56 or .223 Wylde. TBH the finish work on the carriers and bolt is just OK to my eye. Proof is in the shooting. I haven't seen or heard about any BCA stuff shooting under 1-MOA. Most seem to be 1-1.5 but still a low enough sample pool to be anecdotal. The one 6.5 barrel I ordered had a flat-out awful crown job and went back.
Those guys have a bunch of new equipment, etc. so the potential is probably there...a lot of the rest will be attention to detail IMO.
We're also going to run one of the BCG's in a 7.5" FA 5.56 and largely dump ~1000 rounds through it in short order; half with a can attached. I wish we could do more but that's a lot of ammo cost testing a $49 buck BCG!