My rifle

[mateba]

I started this build a few months ago. I got a lot of help from 6.5G forum members. Thank you. I'm re-posting my thread and progress on my rifle.

Rifle build http://www.65grendel.com/forum/showthrea...ot-grendel
Scope discovery http://www.65grendel.com/forum/showthrea...too-decide







My barrel was purchased from Brownell's and is a medium contour Satern/Liberty 5R mid-gas 18" .136 sami spec. The rest of the rifle consists of a collection of parts.

Upper:
?Purchased from Karri's Guns. I've seen the same receiver mark on colts. It has a square above the forward assist. IDK, it was cheap. I lapped it by hand without a drill in a vise held vertically and leveled.
Strike ind. dust cover
ALG EMR-V2 15" M-LOK
Magpul FVG M-LOK
extended charging handle
Superlative arms .750 adjustable gas block
Aero Precision SPR mount
Vortex PST Gen I 2.5-10x32mm FFP
Butler Creek scope caps
Midwest Ind. .30cal Flash-comp
Brownell's/Liberty barrel & M/L gas tube

Lower:
Anderson Arms lower w/ closed trigger guard
BCM gunfighter 3 pistol grip
Karri's Guns enhanced combat trigger
Wolff reduced trigger & disconnector spring
Wolff reduced buffer spring
KAK configurable buffer, currently 3oz.
Accu-wedge
ODIN EMR-GEN3

Magazines
1x17 round AA E-lander
4x24 round AA E-lander

Pistol
Springfield Armory 1911A1 Loaded, 45ACP. Scrimshaw grips by Sid Ryan.