6.5 Grendel Forum › 6.5 GRENDEL DISCUSSION FORUMS › 6.5 Grendel Troubleshooting v
cutting a grendel barrell

Linear Mode
cutting a grendel barrell
Bill Alexander
Unregistered
 
#9
11-23-2011, 09:30 PM
Twist is 1 in 9 with a rifle length gas system and a 0.093" gas port. These can be cut to 20" with no problem and require only the cut and crown work. Twist and gas system remains the same. It will get a little more finicky on operation with light bullets.
Reply


Messages In This Thread
cutting a grendel barrell - by concepthomes1 - 11-22-2011, 12:43 AM
cutting a grendel barrell - by mlmiller1 - 11-22-2011, 01:26 AM
cutting a grendel barrell - by concepthomes1 - 11-22-2011, 01:39 AM
cutting a grendel barrell - by bwaites - 11-22-2011, 03:58 AM
cutting a grendel barrell - by StoneTower - 11-22-2011, 05:04 AM
cutting a grendel barrell - by mlmiller1 - 11-22-2011, 01:39 PM
cutting a grendel barrell - by LRRPF52 - 11-22-2011, 05:54 PM
cutting a grendel barrell - by concepthomes1 - 11-22-2011, 06:20 PM
cutting a grendel barrell - by Bill Alexander - 11-23-2011, 09:30 PM
cutting a grendel barrell - by concepthomes1 - 11-24-2011, 11:41 AM
cutting a grendel barrell - by usmc1371 - 11-25-2011, 04:50 AM
cutting a grendel barrell - by Clod Stomper - 12-03-2011, 04:08 PM
cutting a grendel barrell - by usmc1371 - 12-04-2011, 03:43 AM
cutting a grendel barrell - by Rust - 01-09-2012, 05:33 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)