I know this is the wrong place but!!!
#35
Sorry been busy just getting back here (full length resizing) trim to length is 2.610 the. After cleaning and chamfering and Deburring I an bit less I sure. And from the three book I have sierra, IMRpower.com and Lyman 48th max load is 79.5 to 80
Min was 74 to 75 and I was at 77.5.
Reply


Messages In This Thread
I know this is the wrong place but!!! - by howl - 01-16-2017, 10:17 PM
I know this is the wrong place but!!! - by LR1955 - 01-16-2017, 10:58 PM
I know this is the wrong place but!!! - by LR1955 - 01-16-2017, 11:07 PM
I know this is the wrong place but!!! - by Klem - 01-17-2017, 12:10 AM
I know this is the wrong place but!!! - by Klem - 01-17-2017, 01:44 AM
I know this is the wrong place but!!! - by Klem - 01-17-2017, 03:13 AM
I know this is the wrong place but!!! - by Texas - 01-17-2017, 05:02 AM
I know this is the wrong place but!!! - by LR1955 - 01-17-2017, 01:02 PM
I know this is the wrong place but!!! - by Klem - 01-17-2017, 04:34 PM
I know this is the wrong place but!!! - by Texas - 01-17-2017, 05:21 PM
I know this is the wrong place but!!! - by LR1955 - 01-17-2017, 10:26 PM
I know this is the wrong place but!!! - by Klem - 01-18-2017, 01:53 PM
I know this is the wrong place but!!! - by howl - 01-18-2017, 07:06 PM
I know this is the wrong place but!!! - by Ten Ring - 01-27-2017, 12:07 AM
I know this is the wrong place but!!! - by Sticks - 02-14-2017, 11:14 AM
I know this is the wrong place but!!! - by LR1955 - 02-14-2017, 01:20 PM
I know this is the wrong place but!!! - by LR1955 - 02-19-2017, 12:41 PM
I know this is the wrong place but!!! - by LR1955 - 03-15-2017, 07:57 PM
I know this is the wrong place but!!! - by Texas - 04-03-2017, 12:55 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)