10-20-2011, 11:05 PM
Roger that. Injection molding plates are $10k+ per, and that's if you have them made in the People's Republic of Communist China.
I think there's enough strength in the front of the mag and the rear of the mag, but I have no real issues with my CProducts mags anyway...so far, other than the sharp edges on the floor plate and bottom of the mag body. I'll probably get Ranger plates to mitigate the snag hazard for my skin and clothing...
I think there's enough strength in the front of the mag and the rear of the mag, but I have no real issues with my CProducts mags anyway...so far, other than the sharp edges on the floor plate and bottom of the mag body. I'll probably get Ranger plates to mitigate the snag hazard for my skin and clothing...
