Receiver Lapping??
|
Receiver Lapping??
|
01-28-2016, 12:31 AM
montana Wrote:I have put my lapping tool on my lathe 3 times so far. The lapping compound will cut a groove in the face of the tool after some use. Good point Wheel horse! The lapping compound should be cutting a groove of equal depth all the way around the tool. If it isn't, there is something wrong with the flux modulation in the gravitational forces caused by the squared speed of light. :-) |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Receiver Lapping?? - by Double Naught Spy - 01-23-2016, 10:21 PM
Receiver Lapping?? - by montana - 01-24-2016, 01:46 AM
Receiver Lapping?? - by Bill257 - 01-24-2016, 01:59 AM
Receiver Lapping?? - by LRRPF52 - 01-24-2016, 05:02 AM
Receiver Lapping?? - by just_john - 01-24-2016, 04:17 PM
Receiver Lapping?? - by llamaboy - 01-24-2016, 08:13 PM
Receiver Lapping?? - by LRRPF52 - 01-25-2016, 04:46 AM
Receiver Lapping?? - by Dugan324 - 01-26-2016, 05:33 PM
Receiver Lapping?? - by customcutter - 01-27-2016, 03:12 AM
Receiver Lapping?? - by devildogandboy - 01-27-2016, 11:54 AM
Receiver Lapping?? - by Wheelhorse - 01-27-2016, 01:22 PM
Receiver Lapping?? - by montana - 01-27-2016, 02:54 PM
Receiver Lapping?? - by Dugan324 - 01-27-2016, 04:32 PM
Receiver Lapping?? - by customcutter - 01-28-2016, 12:31 AM
Receiver Lapping?? - by sneaky one - 01-28-2016, 03:21 AM
Receiver Lapping?? - by Wheelhorse - 01-28-2016, 04:31 AM
Receiver Lapping?? - by montana - 01-28-2016, 02:57 PM
Receiver Lapping?? - by montana - 01-28-2016, 03:07 PM
Receiver Lapping?? - by customcutter - 01-30-2016, 02:20 AM
Receiver Lapping?? - by 454bore - 02-01-2016, 01:25 AM
|
