11-29-2015, 07:01 PM
BjornF16 Wrote:LRRPF52, that looks like a T7 photo from "Ultimate Reloader" (UR) videos I've seen.
Anyone actually using a T7?
I've been using Rockchucker (Redding dies) and a Lyman powder measure.
It's a slow process.
I've been pondering a setup like T7 to help speed things up. What about a powder measure? UR uses a Redding BR3 measure.
What is a proven and consistent powder thrower?
Bjorn:
I have owned a T-7 for many years. It is the most heavily used press I own and I own a number of presses.
It is a single stage press with a tool head. This is convenient because you don't have to change out dies but it is not a conventional turret that you can easily spin around to load one round at a time. The turret is too difficult to rotate for it to be used like a Lyman or RCBS turret press.
Among the other presses I own is a RCBS turret and that one you can spin around easily. It works for the Grendel but that is about the biggest cartridge I would put through it. I have always had an affinity for turret presses but haven't used it in years. A single stage press only slightly slower than a turret in my experience. Especially if you own a Bonnanza Co-Ax. Changing dies takes about three seconds or less.
For a powder measure, get the Harrel. I have the 90 I believe and it works better than any other measure I have used. It is easy to use, is repeatable, and throws charges more consistently than any other measure I have used.
If you want to load a lot of ammo fast, and want to use ball powder, the progressives are the way to go. Once you have them set up, that is. And providing their primer feed system works reasonably well.
LR55