6.5 Grendel Forum › 6.5 GRENDEL DISCUSSION FORUMS › 6.5 Grendel Build-It-Yourself & Custom Builds v
Build update

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Build update
Bill257 Offline
Member
***
Posts: 66
Threads: 8
Joined: Oct 2015
#7
10-24-2015, 02:28 PM
New record for torquing a barrel - almost 100 foot pounds to get perfect alignment. It was close in the low 90s and went up in small increments to get zero interference. I was on my last try before pulling it apart and lapping the upper again to make a bit more room. Glad I did not have to do that.
Find
Reply


Messages In This Thread
Build update - by Bill257 - 10-23-2015, 02:02 AM
Build update - by LRRPF52 - 10-23-2015, 04:58 AM
Build update - by Steamburn - 10-23-2015, 01:40 PM
Build update - by LRRPF52 - 10-23-2015, 03:16 PM
Build update - by Bill257 - 10-24-2015, 12:33 AM
Build update - by jim_bob - 10-24-2015, 02:01 AM
Build update - by Bill257 - 10-24-2015, 02:28 PM
Build update - by 37L1 - 10-24-2015, 06:37 PM
Build update - by Bill257 - 10-25-2015, 01:36 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)