TTSX OAL - Ogive Issue
|
TTSX OAL - Ogive Issue
|
|
03-28-2011, 11:48 PM
If your OAL gauge is like mine, lose the plastic rod inside of it. The set screw leaves scars on the plastic. I replaced mine with a brass rod and ground the flat area just like the plastic one. You can get brass rod stock at any hobby store. Then, you'll have a more accurate setup and you can adjust the dimensions to accommodate any particular bullet length. It's less than a one evening job.
Hoot |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
TTSX OAL - Ogive Issue - by cornholio1 - 03-28-2011, 04:10 AM
TTSX OAL - Ogive Issue - by sloan - 03-28-2011, 10:20 AM
TTSX OAL - Ogive Issue - by rasp65 - 03-28-2011, 12:03 PM
TTSX OAL - Ogive Issue - by cornholio1 - 03-28-2011, 01:15 PM
TTSX OAL - Ogive Issue - by bwaites - 03-28-2011, 02:40 PM
TTSX OAL - Ogive Issue - by pinzgauer - 03-28-2011, 02:43 PM
TTSX OAL - Ogive Issue - by cornholio1 - 03-28-2011, 03:05 PM
TTSX OAL - Ogive Issue - by longdayjake - 03-28-2011, 03:53 PM
TTSX OAL - Ogive Issue - by cornholio1 - 03-28-2011, 04:04 PM
TTSX OAL - Ogive Issue - by CoolBarrelBill - 03-28-2011, 11:24 PM
TTSX OAL - Ogive Issue - by Hoot - 03-28-2011, 11:48 PM
TTSX OAL - Ogive Issue - by mseric - 03-29-2011, 12:33 AM
TTSX OAL - Ogive Issue - by Hoot - 03-29-2011, 02:04 AM
TTSX OAL - Ogive Issue - by longdayjake - 03-29-2011, 08:34 PM
TTSX OAL - Ogive Issue - by PA_Allen - 03-29-2011, 08:59 PM
TTSX OAL - Ogive Issue - by longdayjake - 03-29-2011, 09:52 PM
TTSX OAL - Ogive Issue - by mseric - 03-29-2011, 10:24 PM
TTSX OAL - Ogive Issue - by bwaites - 03-29-2011, 10:51 PM
TTSX OAL - Ogive Issue - by StoneTower - 03-29-2011, 10:55 PM
TTSX OAL - Ogive Issue - by mseric - 03-29-2011, 11:34 PM
TTSX OAL - Ogive Issue - by mseric - 03-29-2011, 11:38 PM
TTSX OAL - Ogive Issue - by bwaites - 03-29-2011, 11:53 PM
|