Reloading Bench Complete

[NugginFutz]

I'll take some tonite. Think trailer hitch receiver on a smaller scale, with a plate mounted to bar stock that slides in, and is then held in place by a Thumb screw or piece of bent, threaded 5/16" rod.

Then I have a piece of angle iron with similar pieces of square tubing mounted above head height on the wall (I have lots of grandkids who love to help grandpa and don't want them messing with the presses) That piece can hold as many as 6 different presses. (I have presses for each different pistol caliber I load.) It make more sense in pictures.

Well, Bill was quite accurate in his description. Here are the pictures he'd sent tonight.

Receiver, as seen below the bench.


Bare plate, partially inserted.


Lee Press, fully inserted.


Overhead storage rack.


I'm amazed at the growing variety of solutions. This only needs someone to adapt a U-Haul receiver. back the truck up at the range, and get down to some serious on-site high volume reloading!