Wheeler Lapping Tool
|
Wheeler Lapping Tool
|
08-15-2015, 11:27 PM
Mesa1978 Wrote:The one I have is square. I have a friend with a height gauge and the Wheeler I have was +- .005, I was happy with that. .005" over the length of the tool would be acceptable. .005" across the face(where you are trying to square the upper) would not be acceptable. |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Wheeler Lapping Tool - by Keep The Change - 07-30-2015, 12:21 PM
Wheeler Lapping Tool - by am4966 - 07-30-2015, 01:13 PM
Wheeler Lapping Tool - by babue - 07-30-2015, 05:22 PM
Wheeler Lapping Tool - by Keep The Change - 07-30-2015, 05:43 PM
Wheeler Lapping Tool - by Mesa1978 - 08-01-2015, 02:12 PM
Wheeler Lapping Tool - by Keep The Change - 08-01-2015, 02:22 PM
Wheeler Lapping Tool - by Mesa1978 - 08-01-2015, 03:21 PM
Wheeler Lapping Tool - by am4966 - 08-01-2015, 03:40 PM
Wheeler Lapping Tool - by am4966 - 08-01-2015, 03:43 PM
Wheeler Lapping Tool - by NugginFutz - 08-01-2015, 04:21 PM
Wheeler Lapping Tool - by ponce - 08-05-2015, 01:45 AM
Wheeler Lapping Tool - by dmsims21 - 08-05-2015, 02:20 AM
Wheeler Lapping Tool - by Keep The Change - 08-12-2015, 10:57 PM
Wheeler Lapping Tool - by baconmaker - 08-15-2015, 12:09 AM
Wheeler Lapping Tool - by customcutter - 08-15-2015, 11:27 PM
|
