6.5 Grendel Forum › 6.5 GRENDEL DISCUSSION FORUMS › 6.5 Grendel Troubleshooting v
Failure to chamber

Linear Mode
Failure to chamber
razor
Unregistered
 
#1
09-30-2011, 10:51 PM
Need help you guys, New build, liberty 18" barrel,Mega lowwer,Dillon upper. Went to the range Sunday,got set up charged the rifle,it just went CLICK, I said S***,noticed the bolt didnt close all the way,stayed open about 3/8 of an inch.extractor is not going over the case,just hammering it,nice indents on my LAPUA brass.If I take a shell case and maually fit a case under the extractor holding the case inline with the chamber 3 times out of twentyfive times the case will chamber all the way.What am I not seeing?
Reply


Messages In This Thread
Failure to chamber - by razor - 09-30-2011, 10:51 PM
Failure to chamber - by jwilson1985 - 10-01-2011, 02:13 PM
Failure to chamber - by davidj - 10-01-2011, 04:10 PM
Failure to chamber - by MrDraco - 10-01-2011, 05:41 PM
Failure to chamber - by Mutt - 10-03-2011, 07:38 PM
Failure to chamber - by noone - 10-10-2011, 11:01 PM
Failure to chamber - by Glockzilla - 10-24-2011, 03:54 PM
Failure to chamber - by YutYut - 10-24-2011, 05:10 PM
Failure to chamber - by LRRPF52 - 10-24-2011, 11:56 PM
Failure to chamber - by jkingrph - 10-25-2011, 01:47 AM
Failure to chamber - by warthog - 11-10-2011, 01:10 PM

Forum Jump:


Users browsing this thread: 2 Guest(s)