Gas Block & Divots on Barrel
|
Gas Block & Divots on Barrel
|
05-24-2015, 11:19 AM
One is all u need..u can tighten the second one and then take it off....then dimple the mark with a dremel for the second one....I'm a firm believer that clamping is stronger than set screw short of pinning a block but the clamping ones may have difficulty fitting under some handguards
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Gas Block & Divots on Barrel - by Keep The Change - 05-24-2015, 04:15 AM
Gas Block & Divots on Barrel - by NugginFutz - 05-24-2015, 06:27 AM
Gas Block & Divots on Barrel - by cst - 05-24-2015, 11:19 AM
Gas Block & Divots on Barrel - by Keep The Change - 05-24-2015, 12:52 PM
Gas Block & Divots on Barrel - by Keep The Change - 05-24-2015, 01:16 PM
Gas Block & Divots on Barrel - by ricsmall - 05-24-2015, 01:47 PM
|
