Change of plans on the build. Found where to get my raw parts anodized but not sure when I will have time to take them down. Plus I needed a hand guard and most of what I was after was not in stock any where.
So I ordered a Mega Arms upper and hand guard; MKM-520-HA.
Did a quick mockup and I'm impressed. Barrel is a very snug fit. Hand guard is quite sturdy.
Although the take down pin tab is too wide to fit in the couple different lowers I have of different brands. I could trim but I'm not going to. A bummer, but I was planning on getting a Mega lower anyway.
Waiting on the gas block and tube, ..... and little by little need to get a carrier, trigger, etc..
![[Image: 6.5_zpsjngtsken.jpg]](http://i104.photobucket.com/albums/m180/95stroked1500/6.5_zpsjngtsken.jpg)
So I ordered a Mega Arms upper and hand guard; MKM-520-HA.
Did a quick mockup and I'm impressed. Barrel is a very snug fit. Hand guard is quite sturdy.
Although the take down pin tab is too wide to fit in the couple different lowers I have of different brands. I could trim but I'm not going to. A bummer, but I was planning on getting a Mega lower anyway.
Waiting on the gas block and tube, ..... and little by little need to get a carrier, trigger, etc..
![[Image: 6.5_zpsjngtsken.jpg]](http://s104.photobucket.com/user/95stroked1500/media/6.5_zpsjngtsken.jpg.html)