MAGPUL BEV Block
|
MAGPUL BEV Block
|
12-03-2014, 04:20 AM
LRRPF52, being new to this building, I am having trouble envisioning how they are doing that. Is it happening when they remove the barrel nut or flash hider? Since I have billet upper I guess you are saying that a couple of pieces of butcher board and sandwich sideways is best. I am just worried about putting too much pressure and bending the upper with this type of set up.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
MAGPUL BEV Block - by olde sarge - 12-02-2014, 10:52 PM
MAGPUL BEV Block - by LRRPF52 - 12-02-2014, 11:02 PM
MAGPUL BEV Block - by am4966 - 12-02-2014, 11:19 PM
MAGPUL BEV Block - by olde sarge - 12-03-2014, 04:20 AM
MAGPUL BEV Block - by aclark - 12-03-2014, 08:51 PM
MAGPUL BEV Block - by olde sarge - 12-04-2014, 07:50 AM
MAGPUL BEV Block - by LRRPF52 - 12-04-2014, 09:44 PM
MAGPUL BEV Block - by keystone183 - 12-09-2014, 01:56 PM
MAGPUL BEV Block - by am4966 - 12-09-2014, 03:37 PM
MAGPUL BEV Block - by olde sarge - 12-09-2014, 08:19 PM
|
