11-15-2014, 10:52 PM
Ah yes, the difference between SAAMI spec and variants is again illustrated!
The listed dimension is where the throat ends and bore diameter starts.
More significant is the point where the throat gets tighter than the OD so standard bullets. That would be the start of the throat. The shoulder of the bullet won't go further forward than about this point without engraving lands onto the bullet.
The listed dimension is where the throat ends and bore diameter starts.
More significant is the point where the throat gets tighter than the OD so standard bullets. That would be the start of the throat. The shoulder of the bullet won't go further forward than about this point without engraving lands onto the bullet.