So I went the easy route and just bought a complete Grendel upper at a gun show.
Probably not the best place to buy one, but I figure if this doesn't shoot like I want then I'll
get a better barrel.
All parts are a mystery to me, I can say that the M-Lok handguard does fit M-Lok accessories.
I'm still getting other accessories together before I take it out for a range session.
Yeah, I shouldn't have mounted the scope on the handguard but just wanted to take a look at positioning.
After you break in that barrel, 200 to 300 rounds and realize you want a better barrel,you’ve already blown $300 that you could have spent towards a quality barrel. I sometimes buy budget uppers,because they cost less than me getting an upper reciever,handrail and BCG separately. But I sell the barrel on eBay. Usually gets me around $100 and I’ll throw in the gas block if the barrel I’m getting uses a larger one.
Mechnic Wrote:So I went the easy route and just bought a complete Grendel upper at a gun show.
Probably not the best place to buy one, but I figure if this doesn't shoot like I want then I'll
get a better barrel.
All parts are a mystery to me, I can say that the M-Lok handguard does fit M-Lok accessories.
I'm still getting other accessories together before I take it out for a range session.
Yeah, I shouldn't have mounted the scope on the handguard but just wanted to take a look at positioning.
What does the barrel have stamped on it? Any stampings are writing on the bolt?
Holy smokes,
Hope everyone is doing well, I've been able to verify that I've got a BCA barrel. Still haven't shot it yet, but now have a stripped lower and parts on the way. Having read quite abit about the LaRue MBT-2S trigger and talking to a friend that has one. I went ahead and ordered it. Here's hoping.
