Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Suggestion for informal fun
#21
Soon as I find a load my rifle likes I'd like to give this a go.
- Kirk -
Reply
#22
I like it. BC, if you would formalize the rules and target. I'm in. But we need one member to be in charge. It'll never work if we are going back and forth, well let's do it this way and another saying let's do it that way. Make the rules up a stick to em.
Reply
#23
I like it. BC, if you would formalize the rules and target. I'm in. But we need one member to be in charge. It'll never work if we are going back and forth, well let's do it this way and another saying let's do it that way. Make the rules up a stick to em.
Reply
#24
Ahh the challenges of factory loaded ammo. Today was a pretty windy day, constant 10mph wind that was gusting from right to left at 15ish mph. I shot some Hornady Black but was unhappy with the consistency of it. Made an adjustment to my scope based off that round (it shoots the same as factory SST for me). I then shot a 5 round group with my SST.

The first shot was quite high, but the next 4 grouped very nicely (aiming at the right corner of the big diamond) so I made one more adjustment to the scope (did not shoot any further confirmation shots) and decided it was time to try the challenge.

[Image: Qf3CVHI.jpg]

[Image: EFsN3ya.jpg]

I loaded 5 more rounds from the same box of ammo and had at it. I shot bottom right, bottom left, center, top right, and then top left. I was super solid in my setup, prone on bipod with a rear bag. The gun was not moving, every round broke clean and I did not jerk any.

I'm quite angry about the first and last shot of the group! Seriously though my shooting was on point today and each one of those shots felt good. I should have shot a little more to really dial in the zero, but I was getting low on ammo.

I guess it's hard to read my writing on the paper:
-16" Ballistic Advantage Hanson barrel
-Larue MBT trigger
-Bushnell Forge 3-18
-Factory Hornady Custom SST 123gr.

[Image: frrJ4Sr.jpg]
Reply
#25
65Whelen Wrote:I like it. BC, if you would formalize the rules and target. I'm in. But we need one member to be in charge. It'll never work if we are going back and forth, well let's do it this way and another saying let's do it that way. Make the rules up a stick to em.

65, challenge #1 is formalized, 100 yards sighted off target 5 shots on printed target.
The idea was to have different challenges suggested, to keep it fresh. I was also curious after following BFT's thread on accuracy if we could see any trends between build quality, ammo quality and shooter skill.
Reply
#26
Meh, 123 grain Hornady SST ammo.

[ATTACH=CONFIG]14094[/ATTACH]


Attached Files
.pdf   2019 010.pdf (Size: 245.78 KB / Downloads: 16)
.jpg   20190412.jpg (Size: 77.04 KB / Downloads: 90)
Reply
#27
4/12/19
Rem700 blueprinted, BHW blank fitted and chambered myself
PT&G one pc bolt PPC bolt face
Factory trigger, reworked myself
B&C tactical stock
Vortex HST 4-16x44 MOA Reticle
Form1 suppressor, modeled after SiCo omega300, all 17-4 homespun tube and internals. End cap and ASR adapter and brakes from SiCo.

Hand loaded 100gr nosler ballistic tip
Hornady brass
BR-4 primer
30.9grains 8208XBR

Took 4 sight in shots to foul barrel and fine tune zero to 100yds, shot target. Top right shot rifle was sliding off rear wedge bag as shot broke, and I called it, but figured may as well turn in first attempt. Fun test of accuracy, look forward to more!!


Attached Files
.jpeg   319A7E6D-D57D-4C24-A0C4-989A2BD6EB7E.jpeg (Size: 73.25 KB / Downloads: 105)
Member since 2011, data lost in last hack attack
Reply
#28
Interesting results I assumed the average score would be 10-15? But it seems to be more challenging then i thought?
Reply
#29
I hope to get to the range tomorrow, will give this a go!!
Knowledge and understanding leads to Wisdom.
Reply
#30
Not bad, for my first try, could do better. This was with my hunting load.

18" Larue
Vortex Viper 6.5-20x50
Nosler 129 ABLR
30.0g Leverevolution
CCI-450
Hornady brass
COL 2.260

I've got 1000 Nosler 123 CC and working up a load for it in my Larue. Should be able to make an improvement.


Attached Files
.jpg   IMG_20190420_153236.jpg (Size: 307.52 KB / Downloads: 77)
Reply
#31
Tougher than it looks. Maybe the 200 bullets I ordered may not be enough....:confused: Bad Pic
Ballistic Advantage 20" DMR
Larue Mbt
Athlon Midas 4.5X27
Sierra 120MK
GM205M
Starline Brass
2.250 OAL
3 donuts and a small coffee Wink

[url=[Image: 47616780402_0fcb997d8c.jpg]6.5 Grendel challenge by Michael Smith, on Flickr][Image: 47616780402_0fcb997d8c.jpg]6.5 Grendel challenge by Michael Smith, on Flickr[/URL]
Reply
#32
Finally managed to get a point. Hurried the lower left and knew it was bad the moment the shot broke.

Hornady Black 123grain
18 inch group buy barrel
Larue MBT trigger
Athlon 2.5-15


Attached Files
.pdf   1 POINT.pdf (Size: 443.7 KB / Downloads: 6)
.jpg   one point.jpg (Size: 135.51 KB / Downloads: 45)
Reply
#33
APRIL RESULTS:

7points:

BC hunter
18" Odin, larue MBT,
Athlon 4.4-27x50, hornady AG 123 hpbt

Pinrtreebbs
Howa 1500

65 Whelen
18" larue, MBT, vortex 6.5-20x50
Nos 129ABLR 30.0 levervolution, cci 450

Popeye
Ballistic Advantage 20" DMR larue MBT
Athlon 4.5-27x50
Sierra 120 MK, GM 250M, starliner brass. 2.250 OAL

4 POINTS

Ricsmall
Remington 700 custom, vortex 4-16x44
Nos 100 BT, 30.9 8208XBR, BR-4, Hornady brass.

3 POINTS

Bchunter's Brother
Ballistic Advantage 16" Hanson profile
Larue MBT, vortex 2.5-10 x42
Hornady Black 123 ELDM

Imaguy3
16" Ballistic Advantage Hanson profile
Larue Mbt, Bushnell force 3-18
Hornady custom factory 123 sst.
Reply
#34
Congrats!
I'll be in this months (May) contest. Score to beat is 7 so far. Can't win if you don't play! Smile
Reply
#35
Labrat198 Wrote:Finally managed to get a point. Hurried the lower left and knew it was bad the moment the shot broke.

Hornady Black 123grain
18 inch group buy barrel
Larue MBT trigger
Athlon 2.5-15

May summary:
Labrat with one point, and factory black.


Everyone get out there in June, someone needs to break into double digit score!
Reply
#36
BCA 24“ complete rifle
Bushnell Trophy Xtreme X30 6-24x50
LaRue Tactical MBT-2S Trigger

120 Sierra MK, 27.8 Power Pro Varmint, 2.280" OAL, CCI 450 primer, Hornady case. Temp 55, wind 5-15 m.p.h.
Sandbags front and back. No muzzle device (only thread protector).


Attached Files
.jpg   rsz_lucky_lemon.jpg (Size: 51.77 KB / Downloads: 44)
Reply
#37
I'm working hard to get out and try this one. This informal challenge is very interesting.

-Mac
Reply
#38
[ATTACH=CONFIG]14412[/ATTACH]
Odin 18" athlon 4.5-27x50

120 pro hunter
27.8 grains tac
Cci400 hornady brass
2.230" COAL


Attached Files
.jpg   Odin prohtac.jpg (Size: 215.39 KB / Downloads: 40)
Reply
#39
Is this for ARs only or can us bolt gun shooters get in on the fun?

Sinclair
"A Patriot must always be ready to defend his Country against his government"
Edward Abbey

"Stay out of trouble, Never give up, Never give in, Watch you're six, Hold the line, Stay Frosty."
Dr. Sabastian Gorka, Hungarian by birth, American Patriot by Beliefs.
Reply
#40
If it's Grendel it should be legal as far as I'm concerned.
Reply


Forum Jump:


Users browsing this thread: 4 Guest(s)