Anyone use PF brand barrels?

[Cloverleaf]

As the title states does anyone have experience with these barrels? I ordered a PF 936 barrel about a week ago. Im sure its a great barrel, just curious if anyone has tried them yet.

[A5BLASTER]

Yep PF barrels, uppers and rifles have a huge following on this fourm.

I have a 12.5 inch criterion barrel he made for me. It's my daily driver.

[Cloverleaf]

I plan on buying a Bartlein from him in the near future. Im just curious how the PF cut rifled 5r barrels stack up against the the high end barrels like Bartlein, Kreiger etc.

[ricsmall]

If mark is using them in his sticks, they’ll stack up just fine. Buy with confidence, because if for some reason the barrel won’t perform, he is second to none in CS.

[Cloverleaf]

Well I guess ill have to report back when get it and run some loads through it. I haven't read any reports on here about them so maybe ill be the first. Im very confident it'll be a shooter.

[CxAgent]

That is the barrel I also bought. Mine is 24". I hve had it out 3 time and not alot of rounds through it. It is a shooter. Keep in mind I am typically a 1 to 1.25 moa shooter on a gas gun. This is from the 2nd round of a seating gepth test. Here is the load mark recommended for the barrel. 8208. 28.3 Grains with 123 Grain Sierra SMK or 123 Lapua Scenar. COL 2.265. Doing load development I found that 28 grains had similar verticle to 27.7 and 28.3. Rhen wnt to seating depth. Here is the results.

[ATTACH=CONFIG]16797[/ATTACH]

[Cloverleaf]

Thanks CxAgent, I bought the 20" with a timed lmd muzzle brake. How long did it take for you to receive the barrel? Good shooting and thanks for sharing your results.

[CxAgent]

Ordered on 2/25/2020 delivered on 7/29/2020