Picatinny Forearm Rail mount for Bell & carlson stock?

[SDguy]

Hello All, I am looking to mount a Picatinny Forearm Rail on a VG Bell & Carlson stock for a CZ 527. Expect the rail mount would benefit greatly from at least a light skim cut for a flat surface to mount the rail. any one here does or seen this implemented in a favorable fashion? I am looking for ideas in terms of technique & rail choice.

One rail consideration linked below. Thank you for your thoughts.


https://www.midwayusa.com/product/1019571883?pid=601384

[SDguy]

Ended up epoxy bedding this one. May try Epoxy putty in the future. The runny epoxy was less than handy with the large gaps to be filled.

[MonkTX]

Ended up epoxy bedding this one. May try Epoxy putty in the future. The runny epoxy was less than handy with the large gaps to be filled.

I always used JB Weld to bed my scope rails back when I was foolish enough to buy Remington 700's.