Posts: 9
Threads: 4
Joined: Dec 2019
01-02-2020, 09:11 PM
(This post was last modified: 01-02-2020, 09:39 PM by TwoStrokeTyrant.)
Hello everyone. I am new to the forum. I am also new to the 6.5 Grendel(and precision/long range shooting in general). I have decided to build a 6.5G upper for an existing Noveske lower that is was built for a .223 SPR build I did. I have decided to go with JP Enterprises for all of the upper parts(receiver, barrel, bolt/bcg, gas block)except for their handguard as I just do not really dig their offerings. It is going to be a 22 inch barreled upper. I want something sturdy but still lightweight as it will be a bench/range gun but also a coyote/hog gun that will be humped through Texas brush. I would also prefer M-LOK compatibility as this is what I use on my other rifles and carbines. I am looking at the offering from Grendel Hunter as it seems to meet my requirements while being pretty affordable but I am not certain of the quality or the integrity of its mount-up. Looking for suggestions in the 18-20 inch range that are free floated and right around the $150-$175 mark. Thank you for your time
Posts: 2,098
Threads: 42
Joined: Feb 2015
Seekins SP3Rv3 Rail System or NOXs
Posts: 4,287
Threads: 156
Joined: Jan 2017
Midwest Industries, when I want to go over $100 but stay reasonable. If under a c-buck, the matrix HGs from joebob's.
But definitely you should consider the Midwest indus, they have a couple in M-lok.
"Down the floor, out the door, Go Brandon Go!!!!!"
Posts: 11
Threads: 2
Joined: Oct 2019
I highly recommend something in carbon fiber. I just bought my first one and it's fantastic! I think it's made by precision reflex. Really light, makes a 20" barrel balance well, nice for off hand shooting.
Posts: 149
Threads: 14
Joined: Dec 2019
I agree on carbon fiber for certain applications. I am using a Faxon carbon fiber handguard on my Grendel and plan on using the same one on the next Grendel build.
Posts: 9
Threads: 4
Joined: Dec 2019
I appreciate everyone?s input. I think I am going to go with the Seekins. I am still tentatively considering the Lancer carbon fiber offering though. I will just have to see what I can spend by the time I actually get the build underway
