+- 6.5 Grendel Forum (https://65grendel.com)
+-- Forum: 6.5 GRENDEL DISCUSSION FORUMS (https://65grendel.com/forumdisplay.php?fid=3)
+--- Forum: 6.5 Grendel Build-It-Yourself & Custom Builds (https://65grendel.com/forumdisplay.php?fid=9)
+--- Thread: Marking the BCG?? (/showthread.php?tid=9155)
Marking the BCG?? - JJ_BPK - 03-19-2015
My little family is growing. I now have a BCG for my 5.56, Beowulf, in process Grendel & in the parts bin 7.62x39. I have two lowers and of course separate uppers for each cal.
I want a simple but permanent way to mark the bolt & carrier as sets. I know the carriers are interchangeable, but I don't want to take them apart to eye-ball the bolt.
I'm thinking I drag out the dremel and scribe caliber on each.
Suggestions??
Marking the BCG?? - motoxxx_ryder - 03-19-2015
Look into laser engraving, they should be able to do something easily on the BCG so you can even verify when viewing through the port. its a bit pricy but it will look clean and be extremely effective.
http://www.artatarms.com/pricing.html
a review on his work
http://www.sincityprecision.com/?p=3972
Marking the BCG?? - am4966 - 03-20-2015
Yes laser work on the Bolt Carrier and bolt. Companies that I'd personally look at
http://www.microlaserwelding.net
http://www.leoarmory.com
Marking the BCG?? - JJ_BPK - 03-20-2015
Thanks for the replies.
The carrier & dust cover in obvious, but the bolt.
Where do you make the bolt and avoid ware??
[ATTACH=CONFIG]6320[/ATTACH][ATTACH=CONFIG]6321[/ATTACH]
JJ