+- 6.5 Grendel Forum (https://65grendel.com)
+-- Forum: 6.5 GRENDEL DISCUSSION FORUMS (https://65grendel.com/forumdisplay.php?fid=3)
+--- Forum: 6.5 Grendel ARs and Other Semi-Autos (https://65grendel.com/forumdisplay.php?fid=8)
+--- Thread: fluted barrel (/showthread.php?tid=8009)
fluted barrel - olde sarge - 06-17-2014
What are the effects of fluting on an AR740 20" barrel? Will it cause degraded accuracy? Wanting to build as light and accurate as possible. Thanks
fluted barrel - bwaites - 06-17-2014
Done at the proper time and done correctly, fluting does not affect accuracy.
fluted barrel - burkew23 - 06-17-2014
This question about light profiles and fluting came up during the group buy and Dan answered it directly. I found it and pasted his response in red below:
Is there any truth to this remark on the forum thread, “I think a lighter contour barrel is will be nearly as accurate as a bull barrel, but you will probably notice a POI shift after a 10 shot string.”?
Not with our barrels. Impact shift comes from stress remaining in the barrel coming out as the barrel warms. Our barrels are stress relieved in a vacuum furnace so this isn’t a problem.
fluted barrel - joker31 - 07-07-2014
Along the same lines, has anyone had one fluted after being fired 100 rounds or so?
fluted barrel - LR1955 - 07-07-2014
joker31 Wrote:Along the same lines, has anyone had one fluted after being fired 100 rounds or so?
J31:
I believe the barrel makers stress relieve the barrel after fluting. I do not think it wise to flute it without stress relieving.
LR55
fluted barrel - PrecisionFirearms - 07-07-2014
Stress Relieving is done before fluting by most I know in the industry. According to Lilja, Bartlein, and Kreiger, fluting is the last step in the process of making a barrel. Done with coolant and sharp tooling, the temp of the barrel does not exceed ambient temps. We have found no difference in accuracy with or without fluting.
fluted barrel - LR1955 - 07-07-2014
PrecisionFirearms Wrote:Stress Relieving is done before fluting by most I know in the industry. According to Lilja, Bartlein, and Kreiger, fluting is the last step in the process of making a barrel. Done with coolant and sharp tooling, the temp of the barrel does not exceed ambient temps. We have found no difference in accuracy with or without fluting.
OK, there you go!
LR1955