+- 6.5 Grendel Forum (https://65grendel.com)
+-- Forum: 6.5 GRENDEL DISCUSSION FORUMS (https://65grendel.com/forumdisplay.php?fid=3)
+--- Forum: 6.5 Grendel Photo Gallery (https://65grendel.com/forumdisplay.php?fid=16)
+--- Thread: My Grendel Build. (/showthread.php?tid=23842)
My Grendel Build. - Stugotz - 10-17-2021
I built this rifle up specifically to shoot hogs and coyotes. Build is as follows:
Criterion 22" SS barrel with an adj. gas block
Noveske N4 Lower
Geissele Nat Match 2 stage trigger
Magpul UBR stock
Wilson CB Heavy Duty Billet Upper
WMD Nickel Boron BCG
Ranier Arms charge handle
Aero Precision 15" hand guard
Lantac Dragon muzzle brake
I topped this off with an N-Vision HALO LR50 Thermal and like it so much, I bought an N-Vision ATLAS 50 thermal Bino's
I have a Rex Silentium Mod X can on order (which is presently in jail). I'm hoping it's freed by January for my hog hunt down to Texas!
My Grendel Build. - VASCAR2 - 10-18-2021
Looks like a great build and ought to be a awesome hunting rig.
My Grendel Build. - SDW - 10-28-2021
How do you like that Wilson billet upper? And how's the fit on your barrel? was it tight or did you need to bed it?
I'm slowly putting together an upper with a Wilson SS 22" fluted barrel. I planned to wait until Vltor gets their MUR uppers back in stock, or until my "backorder" becomes available; I have one on another Grendel, no complaints. Curious about these Wilson Combat uppers though now.
My Grendel Build. - Stugotz - 10-29-2021
Barrel upper fit was very tight. I ended up placing the barrel in the freezer for 24 hours before I inserted it into the Wilson upper. (I took a propane torch and carefully 'warmed' the barrel end of the receiver). It would have been an extremely difficult fit other wise. With reloads so far tis build is producing 7/8" - 5 shot groups off the bench. (This with the N-Vision HALO 50LR thermal). EXTREMELY pleased to say the least!
My Grendel Build. - SDW - 10-29-2021
Nice looking setup. I'm sure it all works well together.
I have to pull out the old propane or map gas torch once in a while. Like when dealing with BCM uppers or Bravo handguards. Never had to resort to placing anything in a freezer though, so far.
Surprisingly though, my Vltor MUR wasn't tight at all over the BA DMR barrel I'm using with it. Slipped in and comes out again fairly easily. So I bedded it with brass shimming material. .004" thick. Worked out very well. I've gotten that setup down to .5-1.0 MOA with some of my handloads. That's good enough for me.
From what I can see, the Wilson upper looks even beefier than the MUR. I assume there are modern handguards it wouldn't be compatible with.