+- 6.5 Grendel Forum (https://65grendel.com)
+-- Forum: 6.5 GRENDEL DISCUSSION FORUMS (https://65grendel.com/forumdisplay.php?fid=3)
+--- Forum: 6.5 Grendel Bolt Actions & Single Shots (https://65grendel.com/forumdisplay.php?fid=17)
+--- Thread: Howa legacy mini action 22" (/showthread.php?tid=21704)
Howa legacy mini action 22" - Wabbit87 - 07-24-2020
So I picked this up right before the pandemic and finally got around to shooting it... Less than desirable to say the least 100 round to break in the barrel and it settled at 1moa and that would be perfectly fine for a hunting rifle using 130eldm 30gn lvr 2.260
So looking to order a Mcgowen barrel #8 heavy target barrel 26" and a boyds at one
Anyone know the best way to pop the factory barrel off?
Howa legacy mini action 22" - biodsl - 07-24-2020
Wabbit87 Wrote:Anyone know the best way to pop the factory barrel off?
This would be the best way for me
https://www.gunsmithusa.com/ I sure others will have more useful suggestions.
Howa legacy mini action 22" - Lemonaid - 07-24-2020
As a general method of removing a threaded on barrel you use a barrel vise and a receiver wrench, both with inserts for particular barrel contours and receiver shapes. Brownells is a good source of tools needed. https://www.brownells.com/gunsmith-tools-supplies/general-gunsmith-tools/vises-accessories/barrel-vises/barrel-vise-prod41623.aspx
If you are good at making tools, you can make serviceable home brew ones based on previous designs.
Or you could take your project to your local gunsmith.
Howa legacy mini action 22" - ricsmall - 07-25-2020
If its like most howas and vanguards Ive messed with, youll need to put in lathe and cut a relief in front of receiver. These barrels are put together with a hydraulic torque wrench thats huge. What I was told anyway.
Howa legacy mini action 22" - A5BLASTER - 07-25-2020
ricsmall Wrote:If its like most howas and vanguards Ive messed with, youll need to put in lathe and cut a relief in front of receiver. These barrels are put together with a hydraulic torque wrench thats huge. What I was told anyway.
Help a friend of mine take off 5 diffrent howa barrels. Two from minis and the other 3 from 1500 sized actions.
We used a vise block to he had that holds the action and a wrench head made to fit the barrel and a breaker bar and turned them right off. Not to sure how much torque they used to install and set headspace and all that but I didn't find it all that difficult to break them free with a breaker bar and 3 foot cheater pipe.
Installed the new barrels the same way.
Howa legacy mini action 22" - flatland1 - 07-26-2020
I'd never been able to remove a regular Howa 1500 bbl without taking a relief cut on the bbl shank with a parting tool right up against the receiver face - until they started equipping their actions with the HACT 2-stage triggers. After that, I found that it was easier to remove a factory Howa bbl than it generally is to remove a Rem M700, using a good bbl vise & Brownells action wrench. For use on a Mini action, I slit a piece of fairly heavy rubber hose and slipped it over the top of the Mini action before clamping the action into a M70 top on the Brownells action wrench. The OEM Mini bbls break loose pretty easily.