+- 6.5 Grendel Forum (https://65grendel.com)
+-- Forum: 6.5 GRENDEL DISCUSSION FORUMS (https://65grendel.com/forumdisplay.php?fid=3)
+--- Forum: 6.5 Grendel Ammunition & Reloading (https://65grendel.com/forumdisplay.php?fid=10)
+--- Thread: 100GR AMAX and H322 (/showthread.php?tid=21148)
100GR AMAX and H322 - 65GbySeven - 05-01-2020
Looking to develop a load with "On-Hand" components.
100GR AMAX
H322
Hornandy Brass
CCI 450 Primers
Thinking 2.245 COAL but open to suggestions
Can anyone fill in the blank of a starting load and max load for the H322?
Educated Guess is 26.0-29.0 based on Hodgdon 100 Nosler BT Data.
100GR AMAX and H322 - VASCAR2 - 05-01-2020
Hornady manual list cartridge over all length of 2.245 for 100 grain A-Max which is a pretty short bullet and needs to be seated a little deeper in most 6.5 Grendel barrels. I have to seat 95 grain V-Max at the same length (2.245) or the bullet will stick in the lands. I dumped a whole cartridge of powder in my lower trying to extract a V-Max which was seated to long in my first 6.5 Grendel AR-15.
Hodgdon list loading data with H-322 for Nosler 100 grain BT C.O.A.L. of 2.200.
Starting Load
Grains26.0
Velocity (ft/s)2,420
Pressure36,700 PSI
Maximum Load
Grains29.0C
Velocity (ft/s)2,716
Pressure49,800 PSI
Honestly I think the Hodgdon data is close enough to 100 grain A-Max I would start on the low end and work up using no more than .3 grain increase in powder charge.
Sounds like you and I thinking the same although Ive never used H-322 powder.