+- 6.5 Grendel Forum (https://65grendel.com)
+-- Forum: 6.5 GRENDEL DISCUSSION FORUMS (https://65grendel.com/forumdisplay.php?fid=3)
+--- Forum: 6.5 Grendel ARs and Other Semi-Autos (https://65grendel.com/forumdisplay.php?fid=8)
+--- Thread: Tight Charging Handle (/showthread.php?tid=15007)
Tight Charging Handle - bj139 - 01-03-2018
Anyone have a problem with a new charging handle being tight in a new receiver?
I switched the new charging handle in an old receiver and put the new handle in the old receiver and it seems fine.
Maybe the handle is a bit bent or something.
I took a few measurements and the old and new handles were the same within a few thousandths at the anterior end.
I put a new receiver on the 24" Radical Firearms 6.5 Grendel barrel I bought from a member here.
I put a toothpick in the gas block to hold the gas tube until I get around to pushing the roll pin in.
I can't forget to do that or I might have problems.
Tight Charging Handle - VASCAR2 - 01-03-2018
Is the new charging handle dragging on the top of the lower receiver in front of the butt stock. Not sure if the new charging handle is a little thicker or a little tighter fit between new upper and lower compared to the old lower. If the charging handle is dragging on top of the new lower receiver it’ll probably wear in.
Tight Charging Handle - bj139 - 01-03-2018
I was just trying the fit of bolt and charging handle so it was only the upper receiver not mounted on a lower.
I had to push really hard to get it all the way in. I lubed it with Rem oil and it only made it slightly easier.
Maybe I'm getting too old.
Sorry, the thought just occured to me it sounded like a different subject.Like I said, each slid better in another receiver so I will just leave it at that.
Not sure if that has a different meaning.
Tight Charging Handle - Lastrites - 01-04-2018
Could be the top pad may be a bit thick for that particular receiver or the CH may have a little too much anodizing so looking for wear marks would be key and should show themselves pretty quickly. On one CH I have, I took OOOO steel wool and oil to it to smooth it out a touch which seemed to help considerable in smoothing it up without compromising the finish.
Tight Charging Handle - just_john - 01-04-2018
Is there any kind of additional coatings - cerrocoat or ? Some of these are additive processes which will narrow the slot that the charger slides thru. It doesn't change it by much but can be just enough. I got some uppers that were coated and the bolt carrier was a tight fit.
Tight Charging Handle - bj139 - 01-04-2018
I was surprised how loose the new charging handle was in the older receiver.
I just thought it odd that it would be so tight in the new one.