![]() |
|
6.5 Grendel VS 300 AAC? - Printable Version +- 6.5 Grendel Forum (https://65grendel.com) +-- Forum: MARKSMANSHIP TRAINING FORUM (https://65grendel.com/forumdisplay.php?fid=6) +--- Forum: Technical Knowledge (https://65grendel.com/forumdisplay.php?fid=28) +--- Thread: 6.5 Grendel VS 300 AAC? (/showthread.php?tid=1113) |
6.5 Grendel VS 300 AAC? - bwaites - 12-17-2011 Sounds good! 6.5 Grendel VS 300 AAC? - Rambozo - 12-17-2011 recon562001 Wrote:I have been looking at the numbers and the AAC shoots a 125 grain 7.62 projectile at 2250 FPS producing 1405 foot ponds out of a 16 inch barrel while the Grendel shoots a 123 grain at 2650 FPS producing 1917 foot pounds from a 24 inch barrel. No. Performance only appears equal superficially. Both bullets of similar weight will not have the same BC due to the difference in diameter. All else being equal, the smaller diameter bullet will have the higher BC. The higher the BC, the better the bullet will carry it's velocity. That means that the 6.5 will do better at further distances. 6.5 Grendel VS 300 AAC? - jwilson1985 - 12-18-2011 and the 300aac was ment to run sbr and suppressed...there is no point to have a barrel on a 300aac longer then 16"s 6.5 Grendel VS 300 AAC? - BjornF16 - 12-18-2011 I'm not an expert, but I would think sectional density should be considered as well for penetration: 5.56 SD (68 grn) = .194 300 SD (125 grn) = .188 6.5 SD (95 grn) = .195 6.5 SD (120 grn) = .246 What would be the optimum PDW bullet (inside 100 yds)? 6.5 Grendel VS 300 AAC? - Rambozo - 12-18-2011 BjornF16 Wrote:I'm not an expert, but I would think sectional density should be considered as well for penetration: I would imagine so. 6.5 Grendel VS 300 AAC? - JASmith - 12-18-2011 BjornF16 Wrote:...What would be the optimum PDW bullet (inside 100 yds)?Any of these calibers should do very well inside 100 yards. The choice of caliber and bullet might be decided by what you might like for plinking or other informal shooting. Informal shooting is one of the best ways to become very familiar with your firearm operation and quirks unless you have the fiscal resources and time to go through formal training and the follow-up intensive practice. 6.5 Grendel VS 300 AAC? - stanc - 12-18-2011 BjornF16 Wrote:What would be the optimum PDW bullet (inside 100 yds)?For a military PDW? I'd say it'd be one that has lightest weight and lowest recoil (for maximum shootability/hit probability when used by personnel who get little range time). Plus, it should be in a standard caliber. IMO, that means: - 5.56x45 w/45-55gr bullet, if you consider a SBR to be a PDW. - 9x19 w/90-100gr bullet, for a holsterable PDW. 6.5 Grendel VS 300 AAC? - BjornF16 - 12-18-2011 Not military PDW...personal PDW. 6.5 Grendel VS 300 AAC? - stanc - 12-18-2011 For private use, there are too many variables to say there is one optimum PDW bullet. The optimum bullet, caliber, and weapon would depend on an individual's personal situation. 6.5 Grendel VS 300 AAC? - stanc - 01-21-2012 [video=youtube;u5nvFoQDJUI]https://www.youtube.com/watch?v=u5nvFoQDJUI[/video] Anybody got a Grendel LMG, yet?
6.5 Grendel VS 300 AAC? - bwaites - 01-21-2012 Wow, a necked up .223 runs from the same links as a .223, who'da thunk it! 6.5 Grendel VS 300 AAC? - stanc - 01-21-2012 bwaites Wrote:Wow, a necked up .223 runs from the same links as a .223, who'da thunk it!Well, that's sorta the point, in the context of the thread title. Regarding conversion of belt-fed machine guns, .300 Blackout has a decided advantage over 6.5 Grendel. 6.5 Grendel VS 300 AAC? - Variable - 01-21-2012 So should I convert this to .300 Blackout? ![]() Oh wait, they can't even fill everybody else's 5.56 orders... Nevermind! ![]() While it'd be cool, I'd much rather have mine done over in Grendel any day!!!
6.5 Grendel VS 300 AAC? - stanc - 01-21-2012 Variable Wrote:While it'd be cool, I'd much rather have mine done over in Grendel any day!!!Oh, if only it could be done... I'll see if I can find my magic wand. It must be here somewhere.
6.5 Grendel VS 300 AAC? - bwaites - 01-21-2012 stanc Wrote:Well, that's sorta the point, in the context of the thread title. Yep, another belt fed with all the great ballistics of the 7.62x39! That's a winner, for sure! Accurate out to 150 yards or so, (well, maybe 300). LOL! Absolutely NO advantage over 5.56 belt feds with even less effective range and ammo that costs more than twice as much, thats a breakthrough? Two completely different animals, one a cartridge with extended range and accuracy, the other a short range cartridge that shines as a subsonic. 6.5 Grendel VS 300 AAC? - LRRPF52 - 01-21-2012 I stopped by DSA's booth at SHOT again yesterday and reminded them that Grendel steel case is around the corner, which will make it the most attractive caliber to do in a belt fed conversion due to cost. .300 AAC in a SAW or Shrike????? 6.5 Grendel VS 300 AAC? - stanc - 01-21-2012 bwaites Wrote:Yep, another belt fed with all the great ballistics of the 7.62x39! That's a winner, for sure! Accurate out to 150 yards or so, (well, maybe 300). LOL!Wow. What an incredible distortion of my words. I never said that .300 BLK is by any measure superior to 5.56 for belt-feds, let alone that it's a breakthrough. Quote:Two completely different animals, one a cartridge with extended range and accuracy, the other a short range cartridge that shines as a subsonic.Absolutely. But, if you had to go to war tomorrow morning, which would you rather have: The .300 BLK M249 that actually exists, or the 6.5 Grendel M249 that is no more than a dream? 6.5 Grendel VS 300 AAC? - bwaites - 01-21-2012 stanc Wrote:Wow. What an incredible distortion of my words. I never said that .300 BLK is by any measure superior to 5.56 for belt-feds, let alone that it's a breakthrough. I'd point out that in the context of the thread, the original poster was comparing the Grendel and the .300 BLK in a 16" barrel AR and their associated velocities and energy at the muzzle and downrange, it had nothing to do with a belt fed. As for distortion, I didn't distort anything, I simply stated the facts when it came to the .300 BLK. Its a VERY niche cartridge, and the fact that you can get it to run in a rifle designed for its parent case is no real surprise or breakthrough, is it? Given the choice between the .300 BLK that exists and the 5.56 that exists, I'd take the 5.56 everytime. I'm NOT confident that the .300 BLK M249 will even run consistently. I found it interesting that the belt in that video was so short, wonder why that was? BUT....the .300 BLK as a belt fed for carry is a non starter regardless, and overweight, obese non starter at that. As hinted at in the video, it was done as a one-off for some kind of "I'll show you!" kind of thing. 6.5 Grendel VS 300 AAC? - stanc - 01-21-2012 LRRPF52 Wrote:I stopped by DSA's booth at SHOT again yesterday and reminded them that Grendel steel case is around the corner, which will make it the most attractive caliber to do in a belt fed conversion due to cost.Good pitch! Let's hope they run with it. Quote:.300 AAC in a SAW or Shrike?????They say it's loads of fun to shoot subsonic suppressed. 6.5 Grendel VS 300 AAC? - stanc - 01-21-2012 bwaites Wrote:Given the choice between the .300 BLK that exists and the 5.56 that exists, I'd take the 5.56 everytime.Well, sure. But that doesn't answer my question. Quote:I'm NOT confident that the .300 BLK M249 will even run consistently. I found it interesting that the belt in that video was so short, wonder why that was?No idea. How 'bout a couple hundred rounds? [video=youtube;JGFfzaM0lOk]http://www.youtube.com/watch?v=JGFfzaM0lOk[/video] P.S. Gotta love those Texans. No way you could get away with that here in Kalifornia. |