+- 6.5 Grendel Forum (https://65grendel.com)
+-- Forum: 6.5 GRENDEL DISCUSSION FORUMS (https://65grendel.com/forumdisplay.php?fid=3)
+--- Forum: 6.5 Grendel Troubleshooting (https://65grendel.com/forumdisplay.php?fid=15)
+--- Thread: Failure to eject/ bolt stuck (/showthread.php?tid=19033)
Failure to eject/ bolt stuck - CJW - 11-27-2019
Hang in there Prudii...::
I know something like this will drive you crazy.
The men on this thread know more about gassers than anyone alive.
They WILL solve the problem!
C
Failure to eject/ bolt stuck - Herzo - 11-27-2019
Over gassing can cause this problem also....the bolt starts to move and then stalls before the brass relaxes and releases it's grip on the chamber wall. I had this problem with a carbine with an oversized port. I had to plug and re-drill the gas port in order to salvage the barrel
Failure to eject/ bolt stuck - Lemonaid - 11-27-2019
Looking at the pic of the fired brass it appears to me there is "frosting" which is an indication of a rough chamber in need of more polishing.
It may be a factor in the the problem of failure to extract.
Failure to eject/ bolt stuck - Jakegsxr11 - 12-02-2019
I had a similar issue with one of my Grendels. I fixed it by polishing off the sharp edges of the extractor claw. This was also a group buy bolt. My other group but bolt was fine.