Failure to cycle

[Rivercityjeff]

Yes Sir....

[Rivercityjeff]

Gentlemen, I appreciate your advice.

The gas block alignment and gas tube position will be rechecked. I will report the progress in January....

[Rivercityjeff]

Klem, I appreciate your wisdom and advise. I will check for a gap cut or machining. It would be nice if a .025" shift was all that was needed. Ordered...

[Rivercityjeff]

We are very close to deer season in Texas. It is a shame this will have to wait because, as a single shot, the LaRue barrel had good potential. I have...

[Rivercityjeff]

Klem, the barrel is dimpled for the gas block set screws. I initially snugged the allen screws with my fingers to ensure they center in the dimples...

[Rivercityjeff]

Standard carbine buffers and springs in both lowers. Both lowers have successfully and repeatedly fired my 16" Faxon 6.5 G upper.

...

[Rivercityjeff]

Recently put together an upper, went to the range to test fire, and it would not cycle. So, I opened up the spare part drawer and changed out the gas...