AR mags, the CPD ones called duramag. They allow right up to 2.290, maybe a little +, the stoner mags may not go to there.
I don't think I'm jamming...
User Profile
Collapse
-
PBR, meaning pistol brace rule. The proposed ATF rule on pistol braces, that allegedly would make a pistol an SBR (and thus you'd get arrested for breaking...
Leave a comment:
-
-
I think this issue is not concerning the SBRs in general, but that the 5th circuit continues to have a nationwide block of that "new" ATF pistol...Last edited by grayfox; Yesterday, 09:19 AM.
Leave a comment:
-
-
-
I'm using them in my 22" howa, 18" AR and 20" AR.
Primarily Xbr (28.2-ish dep on the gun), and Ar Comp, again ~28 dep on which gun....
Leave a comment:
-
-
Very interesting... was not aware of that data.
Idk... so just looked it up online in the pdf, and you're right, 31.4 of SWM for 123 Sie hpbt, 2.260,...
Leave a comment:
-
-
Thanks for the info. I'm still quite hesitant, speaking for myself (and others may differ) if SWM is close to I-4064 and RE-15 in burn rate, and Lovex...
Leave a comment:
-
-
What details are in that SW Match load? case, primer, OAL, powder charge.
All of my handloaded 12/12.5-ers in the 120 class have been in the 2200's,...
Leave a comment:
-
-
I don't think they screw off, the ruger american's do.
The howa I think is a single piece bolt knob, there is however a clam-shell type of extension...
Leave a comment:
-
-
One more thing I wanted to share from personal experience, and others' experience may differ but here goes...
The cci#41 primer is said to be equivalent...
Leave a comment:
-
-
Welcome to the bolt-grendel world! the 20" howa is a good choice.
First as to temp sensitive, Lever is likely just as sensitive as CFE, but...
Leave a comment:
-
-
A5's barrel, if I recall, is a CZ bolt action (what, 25" length? I forget exactly) which allowed for a really long OAL, around 2.300 or+.
...
Leave a comment:
-
-
Black stuff... corrosion. maybe some carbon too.
Is the barrel alignment pin broken? I suppose that could be fixed but - well, this is why I said...
Leave a comment:
-
-
I just came back from shooting a few CFE loads for the ablr, with room to go I topped out today at 30.6, 20" 2386. OAL 2.277 and fcd. Starline...
Leave a comment:
-
-
I have an almost unused BA 18" (maybe 20 shots thru); I've decided I'm not getting in to 22 Arc since I have so many "irons" in the fire......
Leave a comment:
-
-
-
Start over, new. That setup is pretty much toast. Or a tomato stake...
Boo-boos are a bummer, been there (different oops however).
And use...
Leave a comment:
-
-
Haven't used carbon, but I do use mainly the 10" midwest ones for a couple rigs I have. Best benefit is easy install with supplied wrench, don't...
Leave a comment:
-
-
Target rifles are heavy like that for 2 reasons: 1 is heat dissipation, the other is less flex and less recoil during the shot. All of these come into...
Leave a comment:
-
No activity results to display
Show More
Leave a comment: