Extractor - Out of Spec or Tolerance stacking ....

[StoneHendge]

OP, don't rule out yourself as the primary culprit. I personally tend to overthink when shooting groups and can get groups like yours if I'm inconsistent...

[StoneHendge]

Thanks 52. Yeah, I was going to try and blow up the pictures last night but it was getting late. The full bolt on the left and the extractor on the JP...

[StoneHendge]

Can you measure the depth of the ultrabolt extractor claw like I outlined above? If it's near .08" or greater, then it will not work in my Lilja...

[StoneHendge]

I'd be hard pressed to think that a Rexus Ultrabolt would work in these barrels. I read "Restores claw geometry to 100% mil-spec 5.56 strength"...

[StoneHendge]

Without going into too much detail, I relaced the extractor on my JP bolt as a precautionary measure with one from Black Rifle Arms back in the Fall....

[StoneHendge]

I don't think anyone saw that coming! This could get really, really interesting. I would suspect that Trump wants to dissolve it and would fold the remnants...

[StoneHendge]

Well, they're up and available. XBR, H4895 and H322. Good luck!

[StoneHendge]

Thanks Klem! You're insight as to what's going on at ADI is helpful as always....

[StoneHendge]

It's nice of them to give a week's notice so everyone can liquidate some assets in order to pay for it!

in all seriousness, hopefully this...

[StoneHendge]

My money says that the cartels are behind this and that it's not for resale, but for their own use.

[StoneHendge]

I did have a few, I remember twice in matches when the cartridge didn't go fully into battery mid-stage. I attributed it to (and the likely final contributing...

[StoneHendge]

Hopefully the industry can get there with the rest of of the system and satisfy the DoD's requirements.

Call it an AR .445 or anything else,...