I am having feeding issues. The upper has an adjustable Odin Works gas block so when I load a single round into my 10 round Elander 6.8/6.5 magazine the rifle fires and the bolt locks open. When I load more than one round the first rounds fires and the bolt cycles and picks up a new round. I pull the trigger and get a click and the round does not fire. I believe that the bolt is not going all the way in battery. Is this the cause of not getting enough gas through the gas block or a magazine issue? I have two new Elander 10 round magazines and it happens with both.
Breaking in a new Odin Works - DSArms upper on RRA lower.
Collapse
X
-
To add to A5's suggestion, make sure the bolt catch if is catching the face of the bolt and not the bottom of the carrier. Also check if the ammo is snagging/hanging up slightly on the edge of the case mouth on the front lip/edge of the mag. How old is the recoil spring and is it the proper length, and what type of receiver extension carbine/rifle?
Comment
-
-
On reloads if you don’t set the shoulder back enough from sizing the bolt may not close completely. If the shoulder isn’t set back far enough or the bullets are seated to long the cartridge maybe difficult to extract when unloading a chambered round.
Comment
-
-
I have two Oden Works barrels one 6.5 Grendel and one 223 both have intermediate length gas port. Both have the tunable gas block and unless you are running a suppressor the gas block most likely needs to be wide open. I run mine wide open and run a carbine spring stock set up and have never had a single problem. Only time I ever had any misfeed problems was trying to shoot 100 gr Sierra HP bullets in the Grendel. They have a huge HP that make a sharp edged flat nose and the bullet would hit the feed ramp and sometimes catch and drive the bullet back into the case and not feed. This bullet is just not semi auto friendly. I have run all sorts of soft point and smaller HP bullets in both 6.5 G and 223s with no problems.
Comment
-
-
Thanks for all of the input. I ordered two new 17 round Alexander arms mags(I will need them anyway)to see if it is a mag issue. I will get to the range sometime next week to adjust the gas block and check to see where the bolt is when it hangs up. My lower is a Rock River from a 24in varmint, rifle length. I measured my reloads and they are all in spec as far as I can tell. I will update after my next range trip. Thanks All!
Comment
-
-
One other thing to know about Elander mags is they will not allow your cartridge over all length to be as longs as ACS/AR Stoner mags will allow. I am sure that Midway's AR Stoner mages are ASC mags. I have had great performance in both of my rifles from the ASC & Stoner mags and they are way less costly than Elander.
Comment
-
-
Range trip today to finish breaking in the barrel. Issue with the feeding problem resolved with the new 17 round Alexander Arms (Elander) mags. No need to adjust the gas block. I noticed that there is a BIG difference in the spring tension between the 10 and 17 rounders. The 10 rounders seem way too stiff. Is there another remedy for this other than keeping the mags fully loaded for a month or so? Now to work on some handloads so I can squeeze the accuracy out of it. Best group on the break in period was with xbr powder and 123 gr Nosler cc. 1/2 in 3 shot group but opened up to 1 and 1/4 for 5 shots.
Comment
-
Comment