I have a new rifle that is smoking my brass pretty bad, such that after 10-12 rounds, there is a problem with the next round fully chambering. also, that unfired round will not extract without prying it out. my impression is that it is over-gassed and extracting the case too early.
So, my question is, if I put an adjustable gas block on it, will it affect currently developed accurate loads? i.e. will I have to start all over again to find an accurate load?
thanks for any help.
So, my question is, if I put an adjustable gas block on it, will it affect currently developed accurate loads? i.e. will I have to start all over again to find an accurate load?
thanks for any help.
Comment