If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I would consider adding a minimum bbl OD at muzzle threads of 0.730". Keep as much meat out there as possible. This way you meet the recommended minimum shoulder requirement that some suppressor manufacturers spec out.
This is definitely down our line of work but getting these requirements all in one barrel is going to cost way over $400. A Bartlein Blank is close to $350 for a bare blank. I estimate around 950 for this barrel with the listed requirements.
Man, I'm a little picky, to be sure, but if I'm building or buying a gun with an accuracy requirement, it had better be shooting (guaranteed) under 1MOA, consistently. For 2 MOA, you buy a mil-spec barrel.
Comment