My ASC 10 rounds have a tendency to tip at the rear of the mag -- any fixes?

[22_boomer]

I use the ASC mags for longer loads and noticed that some rounds were sitting too low at the rear for the bolt to pick up the round. The first few rounds would go just fine but then I would have a feed problem. Are there any fixes for the ASC mags that have this problem.

[ricsmall]

You'll probably want to disassemble those mags and clean the interior of any rough spots using a scotch brite pad. Check the feed lips next to a mag that works and tweak if needed. Make sure the spring is installed correctly so the spring snaps into keeper on bottom of follower. If all that fails send mag back or get some elanders.

Richard

[RicosRevenge]

Are you changing the follower or anything else on the E-Landers?

[22_boomer]

You'll probably want to disassemble those mags and clean the interior of any rough spots using a scotch brite pad. Check the feed lips next to a mag that works and tweak if needed. Make sure the spring is installed correctly so the spring snaps into keeper on bottom of follower. If all that fails send mag back or get some elanders.

Richard

I have elanders but can't use them for long loads.

[22_boomer]

I cleaned up the inside and stretched the spring some to give it a bit more power. The spring was snapped into the little keeper on the underside of the follower. The follower looks to be a no-tilt type so it's funny it would tip or tilt at the rear. I have not compared the feed lips to a good mag since I need to try it out first to see if it's OK now.