Redding dies & #32 rcbs shellholder...g2g or no?

[kegs]

Hi ya grendel shooters. Finally got a couple bolts (1 & an extra, just in case) for my rifle as I sheared one during my first attempt at reloading for this rifle. I am not sure whether the shoulder of my brass was off because I failed to push enough if the brass into the die or if I had the wrong shellholder before, but I want to ensure this combo of the 2-die redding set will work with the #32 shellholder made by rcbs.

I want to have high consistency reloads. I have the reloading book coming from AA, but wanted to see if anyone uses this combo with good success so I can go for another trial run with some ssts, amax, & 120
Noslers pushed by 8208.

All helpful advice aporeciated!

[mongoosesnipe]

shearing a bolt is the effect of too much pressure not a lack of shoulder bump the 32 shell holder and redding dies are good to go but your going to want to cheek you load data and your oal

[kegs]

Thanks mgs!