I can't for the life of me find any data on using the Sierra 120 SMK's with cfe223. Moreover, I am nowhere near confident enought to make any loadings using a burn rate chart. Does anyone have any input?
Also, Im off to do some 600yd testing saturday with a few loads I hope will show some promise. Let me onow what you think. All loadings are using Hornaday once fired brass. FL resized and trimmed.
130 VLD at 2.44 (a couple .000's below where the round would just barely chamber)
Using Blc (2) from (if memory serves me correctly) 28.3-29.4 and a fed205m primer
Sierra 107 SMK at 2.26
Using 8208xbr from 29.1-30.1 also with a fed205m
And finally a Sierra 120 SMK at 2.2
Using blc (2) at 31.3-32.1 again with a fed 205
Rifle basics are, 20" Schnieder polygonal and a headspaced AA bolt and barrel extension sitting on a mega hd billet upper with a U.S optics sn-3
Any help/advice would be well recieved.
-Dave
Also, Im off to do some 600yd testing saturday with a few loads I hope will show some promise. Let me onow what you think. All loadings are using Hornaday once fired brass. FL resized and trimmed.
130 VLD at 2.44 (a couple .000's below where the round would just barely chamber)
Using Blc (2) from (if memory serves me correctly) 28.3-29.4 and a fed205m primer
Sierra 107 SMK at 2.26
Using 8208xbr from 29.1-30.1 also with a fed205m
And finally a Sierra 120 SMK at 2.2
Using blc (2) at 31.3-32.1 again with a fed 205
Rifle basics are, 20" Schnieder polygonal and a headspaced AA bolt and barrel extension sitting on a mega hd billet upper with a U.S optics sn-3
Any help/advice would be well recieved.
-Dave
Comment