If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I have not seen any pressure signs. I did my development in 40+- deg. weather and have shot in up to 80 deg. If I get to shoot this weekend I'll see if that holds for 90+ deg. temps.
NRA life, GOA life, SAF, and TSRA
"I ask, Sir, what is the militia? It is the whole people, except for a few public officials. To disarm the people is the best and most effectual way to enslave them."
questions:
Since the min-max margins are so narrow for the 6.5 Grendel ..
can I use the same data for 120 gr bullets in the re-loading forum with 120 gr SMK HPBTs?
Can I use Hornady brass with the same data that uses Lapua brass?
questions:
Since the min-max margins are so narrow for the 6.5 Grendel ..
can I use the same data for 120 gr bullets in the re-loading forum with 120 gr SMK HPBTs?
Can I use Hornady brass with the same data that uses Lapua brass?
1) Start about 3 grains under max, and work from there.
Hoot, all the Grendel loads were developed with CCI 450 primers, and I suspect that most of us that reload the Grendel have just stuck with those primers, even though we are switching powders. I have thousands of them, whereas finding small rifle primers in my area has been more than difficult for most of the last 3 years.
I would imagine its just the inertia of, "I've used these for so long, its all I use".
I use the same primers and powder for several different guns. Makes it easier keeping a supply of components on hand. I live remote and have no stores with reloading supplies for 300 miles.
Comment