Tweet
Are you guys doing brass prep. Uniforming primer pockets,debur the flash hole ect. Dose Lapua brass even need any work?
-
-
Nope. For my blaster ammo I don't do anything at all. For 600-1000 yard stuff I do chamfer the case mouth, though I'm not sure I can actually prove it helps! -
I trim, chamfer, and deburr new brass, and only clean pockets when reloading. Flash holes in Hornady brass do not need uniforming.Comment
-
My brass is from factory Hornady fired ammo, I do trim, chamfer, and clean primer pocket before reloading. That's after deprimming, sonic cleaning, then resizing. I only trimmed as the case length seemed rather long. Most were over maximum as listed in Hornady reloading manual. Not really sure it helps that much in an AR.Comment
-
Tumble,clean primer pockets,trim, chamfer, load, shoot.Comment
Comment