Just picked up a bunch of it. Supposedly Power Pro 2000MR is very similar. Have to empty some brass and work up some loads with it.
Smp 763
Collapse
X
-
Just happened to find 30 empty 6.5 Grendel cases. Ok I just loaded up 3 rounds each of 30.0 grains and 30.5 grains of SMP 763 for my grendel under the 120 grain Barnes Matchburner. It is over 100 out there and I did let the rifle warm up a bit before I started shooting. Primer is the Federal 205 and Brass is Starline. The 30.0 grain load showed the barest of shine where the ejector was positioned. Shot three into 3/4ths of an inch. The next three showed to be a bit hotter than I will accept but still not outrageous. Slight cratering, barely feel it with fingernail. just a bit more of a shiny spot where the ejector was. POI moved 1/2 inch left and vertically strung into an inch. Think I will back off to 29.5 grains and see how it goes. Kind of like load development backwards. Might maybe get my Magnetospeed out and measure FPS in the morning. Loaded 3 each with 29.0 and 29.5 grains of SMP763 for the morning shoot.
Comment
-
-
Okay this went well. I consider 29.5 grains max in my rifle, primer slightly flattened and 2571 fps average. 29.0 grains gave 2543 fps and a nice little cloverleaf. If you have any of this powder I would start with 28.0 grains and work up in .5 increments. 29.5 grains of BLC2 gave 2511fps with the other components being the same.Last edited by rickt300; 07-25-2023, 04:22 PM.
Comment
-
Comment