I recently switched powders and have about 40 rounds loaded with the previously used powder. I am pulling the bullets with a RCBS collet puller. They had been crimped lightly with a FCD die, but look fine, just kinda shiny where they were in the neck. I don't see any problem using them, but I was wondering about the cases/primers.
The neck tension is slightly reduced, at least I would think so. But I'm thinking they should be ok since I use the FCD die. Just looking for "comforting" opinions, or warnings. Thanks in advance, Gary
The neck tension is slightly reduced, at least I would think so. But I'm thinking they should be ok since I use the FCD die. Just looking for "comforting" opinions, or warnings. Thanks in advance, Gary
Comment