For everyone using Hornady dies

[Jetpig]

Just a DYI tip. Anyone having issues with the original bullet seater collet with VLD type bullets, Instead of spending the cash on the VLD seater collet, I tool my case neck de-burring tool and ran it by hand a few rotations in the original collet. Worked like a charm. No more marks or deformities on VLD bullets!

[Grendelshooter]

Ha! I’m going to try that tonight!

[FRB6.5]

VLD de-burring tool like a KM? or typical 45 degree tool like an RCBS?

[Jetpig]

I had a 129g Accubond to fit with and used the standard de- burring tool. It is as if there was a bit of a lip on the inside edge of the collet. It only took 3-4 revolutions to trim that out. The collet then fit the Accubonds like a glove.

[FRB6.5]

Thanks for the tip!