+ Post New Thread
Page 1 of 58 1 2 3 11 51 ... LastLast
Threads 1 to 20 of 1152

Forum: 6.5 Grendel Build-It-Yourself & Custom Builds

Guys helping guys build guns

  1. Bravo's 16" build thread

    I decided to start a build thread, and document my plans and the actual execution of my build while documenting any difficulties along the way. I...

    Started by Bravo Vector Tango, 04-17-2016 05:32 PM
    9 Pages
    1 2 3 ... 9
    • Replies: 81
    • Views: 2,761
    Yesterday 11:11 PM Go to last post
  2. Swapped Scopes

    Took off the 4x Athlon scope I was testing and threw on the permanent scope, a Vortex 2.5-10x32 FFP Mil/Mil. Also did some testing with a Kestrel...

    Started by alicea8541, 05-29-2016 05:03 PM
    • Replies: 3
    • Views: 115
    Yesterday 02:35 AM Go to last post
  3. Question I know you want a tight upper to barrel connection, but is there too tight?

    I have a few spares laying around and one that I picked up is a BCM 'blem' and it is so tight I can't even get the barrel extension started. I added...

    Started by bob4432, 05-29-2016 08:45 AM
    • Replies: 3
    • Views: 134
    05-29-2016 04:02 PM Go to last post
  4. Side charging upper woes???

    I finally started back on my side charging upper for my next build. I machined the slot in a thin wall upper without any problems. Then I...

    Started by customcutter, 05-14-2016 06:41 PM
    2 Pages
    1 2
    • Replies: 11
    • Views: 493
    05-26-2016 09:51 PM Go to last post
  5. Red X Arms

    Hi all. As I said before I am looking to build a 20" barrelled Grendel. On my hunt for a barrel I found Red X Arms. They say their Grendel...

    Started by 6.5 mm Shoot, 05-03-2016 01:01 AM
    2 Pages
    1 2
    • Replies: 17
    • Views: 706
    05-26-2016 09:30 PM Go to last post
  6. My first 6.5mm Grendel Project - after 3 .223 Rem AR-15s

    Hi there, I registered here because all the german gun forums lack of sufficient information about this young and potent caliber. After some...

    Started by Kohoki, 07-30-2012 10:42 PM
    12 Pages
    1 2 3 ... 12
    • Replies: 115
    • Views: 36,147
    05-25-2016 11:51 PM Go to last post
  7. Criterion vs Lothar Walther

    These barrels with a bolt are both available from PF for about the same price and I'm probably going to go with one or the other. Anyone have any...

    Started by Mark_L, 05-05-2016 11:58 PM
    2 Pages
    1 2
    • Replies: 11
    • Views: 477
    05-25-2016 11:39 PM Go to last post
  8. 6.5 Grendel Build

    Hey guys first time poster. So i have been planning to do a long range ar15 build. What really got me interested was the militarys mark 12 spr. I...

    Started by jgrec2242, 05-25-2016 05:28 AM
    • Replies: 3
    • Views: 192
    05-25-2016 11:32 PM Go to last post
  9. StoneHendge's first 6.5 build - the Ghillie Gwyllgi

    Or GiGi for short- all of my guns with character have names and this one certainly will certainly have character. Claudia is the only other girl in...

    Started by StoneHendge, 05-24-2016 11:19 PM
    • Replies: 2
    • Views: 145
    05-25-2016 02:46 AM Go to last post
  10. LMT enhanced bolt carrier?

    LMT makes an enhanced bolt carrier with altered cam timing (if I described it wrong please correct, ) to help with full auto and SBR rifles. Would...

    Started by jurassic, 05-15-2016 05:56 PM
    • Replies: 4
    • Views: 200
    05-24-2016 08:09 PM Go to last post
  11. 6.5 grendel or 6.8 spc?

    I've been wanting a new build. Can't make up my mind.

    Started by Gunsandcoffee, 05-02-2016 07:03 PM
    6 Pages
    1 2 3 ... 6
    • Replies: 52
    • Views: 2,036
    05-24-2016 04:04 PM Go to last post
  12. Some Grendel Builds and Shout Outs

    Here's a couple of Grendel builds I put together and some shout outs on some of the parts. The first one is a 20" SS HBAR, 1:8 twist with SS comp....

    Started by mcunico, 05-21-2016 03:27 PM
    • Replies: 5
    • Views: 165
    05-21-2016 07:15 PM Go to last post
  13. Satern vs Odin

    I'm building a 20" HBAR for hunting and target shooting. I don't really want to go shorter, becase I want to use a rifle length gas system. I am...

    Started by otter, 05-06-2016 11:16 PM
    2 Pages
    1 2
    • Replies: 11
    • Views: 648
    05-20-2016 03:06 PM Go to last post
  14. 9/16x24 Lightest Brake?

    I'm looking for the lightest possible brake in 9/16x24 for 6.5 diameter bullets. My barrel has an outer width of .74" I believe. Titanium would be...

    Started by pontoon, 04-24-2016 10:57 PM
    2 Pages
    1 2
    • Replies: 14
    • Views: 580
    05-20-2016 03:11 AM Go to last post
  15. Poll Poll: POLL: Type 1 or Type 2

    Hello everyone. I've been reading and researching about the type 1 and type 2 barrels / bolts. It seems like there are more type 1 barrels available...

    Started by Digitalfalcon, 05-16-2016 03:46 PM
    3 Pages
    1 2 3
    • Replies: 23
    • Views: 560
    05-18-2016 12:32 AM Go to last post
  16. Hats off to Bill Geissle……

    I Have a SD3G that I bought for my build a couple of years ago, I like a trigger that is at home on the bench as well as in the field. Not knowing...

    Started by Hoser1, 05-15-2016 12:28 AM
    • Replies: 7
    • Views: 355
    05-16-2016 11:04 PM Go to last post
  17. RRA NM vs SSA-E

    For those in the know, is the ssa-e a huge jump better then the rra nm trigger. I'm running the rra at the moment but just ordered the ssa-e due...

    Started by A5BLASTER, 05-13-2016 05:16 PM
    • Replies: 9
    • Views: 202
    05-14-2016 09:35 AM Go to last post
  18. Love it

    Finally got my Grendel to shoot. After a year and a half, two complete AA uppers and now a Lilja barrel, I've finally got consistent accuracy: 7...

    Started by EPeterson, 05-01-2016 10:05 PM
    • Replies: 3
    • Views: 292
    05-11-2016 03:55 AM Go to last post
  19. Grendel build

    Literally just got done with my grendel build. upload image Still waiting on scope, mags, muzzle brake

    Started by ii's_open, 04-07-2016 10:13 PM
    2 Pages
    1 2
    • Replies: 12
    • Views: 1,092
    05-06-2016 06:22 PM Go to last post
  20. Barrel search

    Looking for a 16 or 18"Good quality Stainless barrel, medium contour fluted and threaded.. any suggestions?

    Started by toolsofthetrade, 05-04-2016 11:06 PM
    • Replies: 4
    • Views: 424
    05-05-2016 06:09 PM Go to last post

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts